General

[ prev topic | next topic ]

dinamo and I-TRAIN

Posted by oups65 on 2017-11-21 19:58

Hello everybody,
I have a free bloc connector on one TM-44. I would like to use it for a turnouts group " as a separate pseudo-block" ("Manual Plug and Play 1_1", section 6.3.1, page 23).
My concern is that I am playing with I_TRAIN and I do not find how to set I_TRAIN parameters to perform it ?
many tks for help.
Philippe

Reads: 0

Link

Posted by oups65 on 2017-11-21 21:26

Hallo,
DINAMO maakt het mogelijk om een wisselstraat als een apart pseudo-blok te declareren ("Handleiding_Plug__Play_1_0", 6.3.1; Pag 24).
Wie kan mij uitleggen hoe ik deze mogelijkheid kan gebruiken in I_TRAIN ?
Vast dank voor reacties.
Philippe

Link

Posted by Frans Staal on 2017-11-22 11:42 Netherlands

Hello Philippe,

this feature (aanvullend blok) of Dinamo is supported by the Koploper program, but not by iTrain. My advise to you is to use a relay to feed power to the double slip from the adjecent blocks of one side. This also applies to two junctions which are connected together with their single sides.

Regards
Frans

Link

Posted by oups65 on 2017-11-24 11:16

will do. Tks Frans.
Philippe

Link

General

Menu